Linear Type Round And Square Bottle Labeling Machine , Sticker
Applicator Machine
Machine function:
Position on the round bottle and square bottle to paste OPP, BOPP
and paper labels which are rolling without glue. This machine will
deliver labels automatically, select and cut labels, glue at both
ends of each label, add labels and smooth out labels.
The machine suits for the application of mineral water, beverage,
food, washing and other industries to realize labels-cutting,
glues-coating and labelling for round bottles and square bottle.
1.3.4. Feeding screw stem
The feeding screw stem is applicable for separating bottles by a
certain length and the bottles are conveyed by the transport line
and then go into the feeding star wheel gullet. Change the screw stem for bottles with different diameters!
Release <the screw stem adjusting handle screw>, rotate
<the screw stem adjusting hand-wheel> to allow adjusting the
anteroposterior position of the screw stem, set at the bottom of
the screw stem groove and level with the starting point of the
guide panel, after adjusting relock <the screw stem adjusting
handle screw>.
Release <the push panel adjusting locking handle screw> to
allow the anteroposterior position of the stop panel adjustable,
during adjusting place two bottles in the screw stem groove to set
the length between the push panel and the bottles to be 1~2mm
appropriately. After finish adjusting relock <the push panel
adjusting locking handle screw>.
Adjusting the combination of the screw stem and the star wheel:
Remove <the screw transmission hood>, release the clamping
screws in the coupling (while the screw stem is rotatable freely),
run the machine by inching to set one tooth of the star wheel at
front of the screw stem, place a bottle at front end of the screw
stem (the big end of the screw stem), rotate the screw stem by
hands to make the bottle wheel go into the star wheel teeth, relock
the clamping screw in the coupling and recover <the screw
transmission hood>!
Changing the screw stem: When the screw stem is changed for the bottle with another
diameter, release the locking handle screw at the screw stem rear
end (the small end of the screw stem), and pull out the rear end
centre pin and draw the screw the screw stem lightly to remove the
screw stem. Guide the front end of the required screw stem into the
front end of the drive shaft, while rotate the screw stem, push it
in the straight direction lightly, after set it in the right
location, insert the rear end center pin and relock the handle
screw. Follow the above steps to re-adjust the combination of the
screw stem, the stop panel and the star wheel!
| Model | SSW-0806R(PO201607007) |
| Maximum label output speed | 60m/min |
| Maximum speed | 30,000 (determined by bottle size and label length) |
| Specifications for labeling bottle | Round bottle and square bottle |
| Labeling precision | ±1mm |
| Total power | 8Kw |
| Power supply | Three phase 380V 50/60Hz |
| Air pressure | 5 Kg f/cm2 |
| Air consumption | 20L/min |
| Outside measurement (LxWxH) | About 3000mm(L)×2000mm(W)×2000 mm(H) |
| Total weight | About 2500Kg |
